Lionelo Mona Manuel De L'utilisateur page 11

1.
Put 4 legs of the low chair (E), front (RR, LL) and rear (L, R) in spots marked
in the seat base (L), front and rear (R, L, R, L), until you hear a characteristic
click (fig. 10).
2.
Fix 2 metal connectors of the low chair (F) between low legs, attach
connectors with 4 screws (N) to the chair legs. To do so, use the Allen key
(O). Assemble the footrest (J) to finish the procedure (fig. 11).
3.
Put the seat with backrest (K) into the seat base (L), and then put the plastic
tray on (I), until you hear a characteristic click (fig. 12).
4.
Put the top silicone tray on (P).
5.
Check if the chair is stable (fig. 13).
6.
Put the child in and secure with 5-point belts located the seat covering.
How to attach the booster seat (2) on the chair:
Attach the booster seat with two fixing belts supplied. Follow the steps below:
1.
Assembly of the booster seat (2) with the use of a fixing belt (M) on the
chair through the seat bottom (K) (fig. 14):
•
Carry the belt (M) through two holes in the seat bottom (K) (fig. 15).
•
Carry the belt through the adult chair and lock the buckle, next tighten the
belt to have a relevant length (fig. 16).
2.
Assembly of the booster seat (2) with the use of a fixing belt (M) on the
chair through the backrest (K) (fig. 17):
•
Carry the belt (M) through two holes in the seat backrest (K) (fig. 18).
•
Carry the belt through the adult chair and lock the buckle, next tighten the
belt to have a relevant length (fig. 19).
•
Check if the booster seat has been properly positioned with the use of
the fixing belt (fig. 20).
•
Put the child in and secure with 5-point belts located in the seat covering.
Suitable sizes of the chair for assembly of the booster seat
on the chair:
Pay attention to the following sizes of the adult chair:
1.
Chair width must not be lower than 33,8 cm.
2.
Chair depth must not be lower than 28 cm.
3.
Chair backrest height must not be lower than 42 cm and higher than 63 cm.
‑ 11 ‑ EN