Télécharger Imprimer la page

Lionelo Sven Plus Manuel De L'utilisateur page 8

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 30
• Insert batteries with the correct polarity.
• Exhausted batteries should be removed from the toy.
• The supply terminals are not to be short – circuited.
• To replace the batteries: use a screwdriver to open the door and access the
battery compartment. Replace the batteries and make sure they are inserted
correctly. Screw the door with a screwdriver.
• The toy cannot be connected to more power sources than recommended.
Assembly instruction
1.
Take the travel baby bed out of the bag and loosen the adhesive straps.
Place the bed on the floor and put the bag aside (see fig. 1).
2.
Separate the legs pulling them apart. Keep the central lock up. Otherwise
handrails will not fit in the right place (see fig. 2).
3.
Pull the middle part of each top rail covered with material so that they fit
into place. Start with the longer rails, and then the shorter ones (see fig. 3).
Note! So that the sides of the cot / handrails are properly blocked, the central blockade
of the floor must be raised upwards. The baby rails will not lock when the floor
is unfolded.
4.
Push the middle lock until the surface is completely flat (you will hear the
click sound) (see fig. 4).
5.
Place the mattress in the baby bed (see fig. 5, 6). Fasten the mattress using
Velcro on the two short sides of the mattress (there are special openings in
the floor for fastening).
Base installation
The base must be attached using the zipper. Once the base is attached, cover
the zipper with a Velcro pad. Slide the reinforcement tubes into the sewn handles
and connect them (they must be paired properly). Place the mattress onto the
tube-reinforced base and fasten it with Velcro.
Canopy installation
Slide the plastic arches into the material guide of the canopy and connect them
in the middle. Place the rear part of the canopy on the baby bed, then stretch
the fabric and attach the canopy to the baby bed using plastic clamp holders.
After the roof has been mounted, it should be pressed several times from the
EN
‑ 8 ‑

Publicité

loading