Codman INTEGRA CereLink 82-6820 Mode D'emploi page 17

INITIAL SETUP
Charge the Battery to Full Capacity
4
Keep the ICP Monitor plugged in for at least 5 hours to charge the battery to full capacity.
Turn on the ICP Monitor
5
Press the Power Button on the front of the ICP Monitor for at least 1 second (see Figure 1). The Power Button will illuminate
to indicate that the device is on. After approximately 20 seconds, while performing internal self-checks, the ICP Monitor will
display the "Codman CereLink" logo. Confirm that the battery is fully charged.
Specify the Language
6
From the Home Screen, select Settings (see Figure 9), then select Set Language (see Figure 10). Choose the desired language.
Set the Time and Date
7
From the Home Screen, select Settings (see Figure 9), then select Set Time/Date (see Figure 10). Adjust the time and date as
needed.
Set the Alarm Volume and Screen Brightness
8
From the Home Screen, select Volume/Brightness (see Figure 9), then adjust desired alarm volume and desired screen display
brightness.
Turn off the ICP Monitor
9
Press the Power Button on the front of the ICP Monitor for at least 3 seconds (see Figure 1). The ICP Monitor will display the
"Codman CereLink" logo to indicate that the shutdown process has started.
17
EN - ENGLISH