Codman INTEGRA CereLink 82-6820 Mode D'emploi page 16

EN - ENGLISH
INITIAL SETUP
Unpack the ICP Monitor
1
WARNING: Use only Codman approved accessories with the ICP Monitor (see the Recommended Accessories and Reordering
Information section).
Remove the contents from the shipping box and verify the following items are included:
• CereLink ICP Monitor (REF 82-6820)
• Power Cord with Region-Specific Adapter Plug (REF 82-6822)
• Rechargeable Lithium Ion Battery already installed (REF 82-6824)
• Extension Cable (REF 82-6845)
• User Manual
After unpacking the contents, inspect the items for any signs of damage. If any damages are discovered, notify the carrier and
the supplier. Retain all shipping contents and boxes for examination.
Prepare the Power Cord Adapter Plug
2
Remove the Power Cord from the package and attach the region-specific adapter plug or cord to the power supply.
Plug the ICP Monitor into AC Power
3
Connect the power supply to the ICP Monitor by inserting the connector end into the Power Input (see Figure 2). Insert the
grounded electrical plug (with three or more electrical pins/contacts depending on the geographical region) of the Power
Cord into a grounded wall outlet and ensure the Power Indicator light is green. Use the Power Cable retention mechanism (see
Figure 3) to prevent the Power Cord from detaching from the ICP Monitor.
Use only provided CereLink ICP Power Supply.
• Use only the CereLink power connection, which provides three or more electrical pins/contacts
depending on the geographical region.
• Connect only to "hospital grade" or "hospital only" receptacles.
Do not attempt to bypass the grounding contact on the CereLink Power Supply by using an adapter.
Earth ground symbol. Connection plug must have three or more electrical pins/contacts.
Figure 14: CereLink Power Supply Configuration
16