BRONDI SD-10 Mode D'emploi page 9

jack and the other end to the telephone jack++.
2. Insert the small plug on the end of the AC adaptor into the DC 9V power jack located on the
rear of your unit. Use only the Center Positive AC adaptor provided with your unit.
3. Plug the AC adaptor into a standard AC wall outlet. Once plugged in, the display will count up
from 0 to 5. After a long beep, the unit will display " -- "to indicate the unit is on, but not set for
answering messages yet, or "Lo" to indicate the battery is dead, weak, or not installed.
4. During AC power failure, a 9V battery provides battery backup so the unit can maintain the
memory information. However, the unit cannot answer incoming calls without AC power.
RECORDING AN OUTGOING MESSAGE (OGM)
This unit can record two kinds of messages: OGM is used when you want the caller to hear the
OGM and then leave a message, OGM2 is used when you only want the caller to hear your OGM,
but not leave a message. The maximum OGM for each message is 30 seconds. The minimum time
for an OGM is 4 seconds.If you have not recorded an OGM and/or OGM2, the answering machine
cannot be turned on.
RECORDING OGM1 (OUTGOING MESSAGE 1)
Press and hold the OGM button for approximately 2 seconds until a long beep is heard. The
display will count down the time left, so begin recording your outgoing message speaking in a
normal tone of voice.
When finished recording, release the OGM1 button. A short beep will sound and the newly recorded
outgoing message will then play once. Make sure the VOLUME control is at a desirable level.
To record a new outgoing message, please repeat steps  and 2.
RECORDING OGM2 (OUTGOING MESSAGE 2)
Press and hold the OGM2 button for approximately 2 seconds until a long beep is heard. The
display will count down the time left, so begin recoding your outgoing message speaking in a
normal tone of voice.
When finished recording, release the OGM2 button. A short beep will sound and the newly recorded
outgoing message will then play once. Make sure the VOLUME control is at a desirable level.
To record a new outgoing message, please repeat steps  and 2.
VERIFYING THE OUTGOING MESSAGE
Press and release the OGM or OGM2 button and the selected Outgoing Message will play. Press
the STOP button to stop playback before the end of the outgoing message is reached.
NOTES:
If the unit detects a dial tone, silence or a busy signal, the unit will hang up and not register the message.

The unit will shut off if a parallel phone is picked up.

When the memory is full, "FU" will appear in the display.

When the battery is low, dead or not installed, "Lo" will blink in the display.

Press the OGM or OGM2 button to hear the respective Outgoing Message.

SETTING THE UNIT TO ANSWER/RECORD MODE (Incoming Messages will be recorded)
Make sure the OGM is recorded. Press the ON/OFF button once and the unit will emit 2 short
beeps and then play OGM.
The message counter will then appear in the display indicating the unit is in Answer/Record mode.
OPERATIONN
EN
2