BRONDI SD-10 Mode D'emploi page 11

will blink in the display. To continue playback, press and release the Play/Pause button again.
To stop playback, press the STOP button and the unit will save the previous messages.
NOTES:
After playing the ICMS, the unit will automatically reset to take new messages.

The maximum recording time for an ICM (Incoming Message) is 90 seconds.

IF MEMORY IS FULL
If the memory is full, the unit will change to Answer-Only mode, play OGM2 and not allow a
message to be recorded.
DELETING INCOMING MESSAGES OR PERSONAL MEMOS
To erase a single message while playing it back, press the DELETE button and the unit will delete
the current message and play the next message.
To delete all the messages, press and hold the DELETE button while in the idle mode (messages not
playing).
SECURITY CODE
This unit can be operated from almost any touch-tone phone. The Security Code is preset to 9.
To change this code, follow the instructions below.
Press and hold the CODE/ ◄◄ button for 2 seconds; a beep will sound and the current code will
blink. Press the RING/ ◄◄ button and/or CODE/ ◄◄ button to change the security code. When the
code setting appears, press the STOP button.
To check the current security code setting, press and release the CODE/ ◄◄ button; the current
security code will briefly appear in the display.
NOTES:
If a power failure occurs and there is a dead or no battery, the Access Code resets to 9.

If you forget the Access Code, unplug the AC adaptor and disconnect the battery and it will reset

to 9.
TURNING THE ANSERING MACHINE ON
Call the answering machine from a separate line.
If the unit is off, it will answer after 8 rings, the unit will emit a 3 second beep.
Enter your security code within 0 seconds, and then the unit will switch to the Answer/Record
mode. If you do not enter your security code within 0 seconds, the unit will stop and disconnect.
REMOTELY PLAYING OGM1, OGM2 REMOTELY RECORDING A NEW OGM
Call the answering machine from a separate line. During the OGM, enter your security code. Press
the "" pad to play OGM or the "2" pad to play OGM2.
Call the answering machine from a separate line. During the OGM, enter your security code.
OGM: Press the "#" and then the "" pad and after the long beep, record your new OGM. When
finished, press the "9" pad and then the new OGM1 will play back. If satisfied, press The "" pad
to end the call or repeat this step to record a new OGM again.
OGM2: Press the "#" and then the "2" pad and after the long beep, record your new OGM2. When
finished, press the "9" pad and then the new OGM2 will play back. If satisfied, press the "" pad to
REMOTE OPERATION
EMOTE OPERATION
EN
4