American Comfort Worldwide ACW200 Manuel Du Propriétaire page 7

This unit can easily be moved from one room to another. In doing, so keep this in mind:
• The air conditioner must stand upright on an even surface.
• Do not position near bath, sink, or other permanent, wet or damp area.
• Keep unit at least 18" from wall, curtains, draperies, or heat sources to insure adequate air circulation.
Figure A
Exhaust
Hose Slide Bar
Connector
Figure B
Air Outlet
Installing Exhaust Hose to Window Slide Bar
Note: The window kit is only designed to be installed with sliding windows or doors.
The window kit is not designed or to be used with casement style windows.
Step 1:
Measure your window kit according to the dimensions of your sliding window. If in case the unit is larger than
your required dimensions, it can be cut using a saw or power tool of the sort. If the unit is too short for your
opening, you can order an additional window kit from our online store to extend it.
Step 2:
Screw slide bar connector into exhaust hose fi rst (Figure A), then spin the exhaust hose into the air outlet located
at the rear of the unit (counter-clockwise) (Figure B).
Step 3:
Insert slide bar connector into adjustable slide bar (Figure C). Extend the Slide Bar length to match the
width of the window (vertically or horizontally), and then tighten the screw to hold the length of the slide bar
(Figure D). Make sure the adjustable slide bar fi ts snug in your window and stays in place.
Proceed to close and lock your window on the Slide Bar to secure in place (Figure E).
IMPORTANT
The fl exible exhaust hose can be extended from 10.25" to 58.5" for mounting.
We recommend that you keep the hose as short as possible to minimize possible loss back in the room.
This length has been designed especially according to the specifi cations of the air conditioner.
Do not use an extension or exchange for a different hose as that may lead to malfunctioning.
The exhaust air must fl ow freely. Any blockage can lead to overheating of the air conditioner.
Handle with care to prevent any kink or bend in the exhaust hose.
Positioning
Figure D
Figure C
Fix one
screw
Adjustable
Slide Bar
5
Figure E
18"
18"
45cm
45cm
Window
Adjustable
Slide Bar
Slide Bar
Connector
Exhaust
Hose