LEVAQUA 720 Serie Mode D'emploi

NOTE: Drawings may not match your product exactly.
INSTALLATION:
1. While holding showerarm, remove existing
showerhead by turning counter-clockwise.
Thoroughly clean showerarm threads,
removing old plumber's putty, Te on tape,
etc.
2. Screw shower mount onto end of shower-
arm and hand tighten. Do not over-tighten or
the showerarm mount and/or showerarm may
be damaged.
3. Grasp showerarm mount and pivot it so
that the hose connection is pointing down-
ward.
4. ATTACHING THE FLEXIBLE HOSE:
The hose accommodates a built in non-return
valve. Make sure to connect correctly
following the instructions below and the label
on the hose.
4a. Place the one rubber washer inside the
conical nut on the side of the hose labeled
"Connect this side to hand held shower".
Screw the conical nut onto shower handle
and hand tighten.
4b. Place the second rubber washer inside
the conical nut at the other end of the hose.
Screw nut onto showerarm mount and hand
tighten.
5. Feed the hose through the shower holder.
Lower the shower handle into the holder until
the conical nut is seated rmly in the holder.
Turn on the water and check for leaks.
CONTROL PANEL OPERATIONS
SIMPLY PRESS ANY BUTTON ON THE CONTROL
PANEL TO ACTIVATE A NEW SETTING, JUST AS
YOU WOULD WITH ANY REMOTE CONTROL.
AFTER A BUTTON IS PRESSED, THE SELECTED
PATTERN WILL BEGIN NEARLY IMMEDIATELY.
THE DEFAULT/FACTORY SETTING IS SPRAY.
The World's First
Digital Shower Head
Instruction Manual For
720 Series
MASSAGE: Enjoy relaxing and rhythmic water pattern.
SPRAY: Experience a full- ow water spray.
COMBO: This setting combines spray and massage.
ECO: Use this setting for an intense, concentrated spray and 20% savings in
water consumption.
PAUSE: When this button is pressed, the ow of water ceases. Simply press the
Pause button again to begin the water ow again.
"PROGRAM (RELAX and ENERGIZE/REFRESH) Both of these settings run for 5
minutes. Both settings use a preset sequence of water spray patterns to set the
selected experience. After the 5 minutes, the water ow reverts back to the
Spray setting.
TIMER: Press the Timer button once for a ve-minute indication. Press the Timer
button twice for a 10-minute indication. To switch off the timer setting press the
button until none of the timer indicators are lit.
When the timer program is complete, the water will pause for a few seconds and
then resume the current spray pattern. Note: timer settings cannot be used
together with either Relax or Energize/Refresh programs on applicable models.
NOTE: IT IS NORMAL FOR A TRICKLE OF WATER TO FLOW
DURING THE PAUSE SETTING.
CAUTION: THE PAUSE SETTING IS NOT MEANT TO BE A SHUT-OFF
OPTION. NEVER LEAVE SHOWER HANDLE IN THE PAUSE SETTING WHEN
EXITING THE SHOWER. ALWAYS TURN WATER OFF AT THE VALVE.
REPLACING BATTERIES
THIS PRODUCT REQUIRES 3 X AAA ALKALINE BATTERIES
Open the battery door by removing the screw under the
rubber stopper. Use a Phillips Head Screwdriver to release
the screw on the battery door. Gently release the latch on the
battery door (see drawing). Remove the old batteries and
insert new batteries, following the +/- marking on the battery
housing. Close the battery door and replace the screw; be
sure to tighten gently. Before securing the battery door be
sure all seals are in place and are secure.
NOTE: PLEASE RECYCLE ALL OLD BATTERIES.
CAUTION: PRODUCT IS WATER RESISTANT AND SPLASH-PROOF,
HOWEVER, NEVER LEAVE THE PRODUCT IN STANDING WATER OR ANY
LIQUID.
CLEANING: Only clean with a mild, non-abrasive detergent and soft cloth. Using any
other cleaning product not speci cally designed for cleaning plastic or metal
surfaces may cause damage to the nish. Clean lter screen (some models) at least
once a year or whenever you notice a drop in water pressure. To clean mineral
deposits, gently rub the rubber nozzles on the face of the shower head to dislodge.
5-YEAR WARRANTY: VEGA INNOVATIONS LLC WARRANTS TO THE OWNER OF THIS
PRODUCT THAT IT IS FREE FROM DEFECTS IN MATERIALS OR WORKMANSHIP AS LISTED
ABOVE FROM THE DATE OF PURCHASE. VEGA INNOVATIONS WILL REPLACE ANY PART OF
THE PRODUCT WHICH IN OUR OPINION IS DEFECTIVE, PROVIDED THAT THE PRODUCT HAS
NOT BEEN ABUSED, MISUSED, ALTERED OR DAMAGED AFTER PURCHASE. THIS INCLUDES
DAMAGE DUE TO USE OF TOOLS, HARSH CHEMICALS OR DAMAGE DUE TO MISUSE. IN THE
EVENT AN ITEM HAS BEEN DISCONTINUED WE WILL REPLACE WITH WHAT WE DEEM TO BE
THE CLOSEST PRODUCT. VEGA INNOVATIONS IS NOT RESPONSIBLE FOR LABOR CHARGES,
INSTALLATION, OR OTHER CONSEQUENTIAL COST. THE RESPONSIBILITY OF VEGA INNOVA-
TIONS LLC SHALL NOT EXCEED THE ORIGINAL PURCHASED PRICE OF THE PRODUCT. THIS
WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS. SAVE YOUR RECEIPT AS PROOF OF
PURCHASE IS REQUIRED FOR WARRANTY ACTION.
HAVE QUESTIONS OR NEED ASSISTANCE?
PLEASE CONTACT US AND WE WILL BE HAPPY TO ASSIST YOU.
CALL TOLL FREE: 1-877-330-5080, 9:00 A.M. TO 5:00 P.M. EST,
MONDAY – FRIDAY.
DISTRIBUTED BY VEGA INNOVATIONS LLC
www.levaqua.com
THIS PRODUCT IS COVERED BY MULTIPLE U.S. AND INTERNATIONAL
PATENTS AND PATENT APPLICATIONS.
IB-720-03-11-00