Centaure MX3 Mode D'emploi page 8

EN
1
About these instructions
2 Intended use
3
General safety instructions
4
Markings on the product
5 Scope of delivery
6
Installation and use
7
Maintenance and servicing
8 Transportation and storage
9
Packaging and disposal
1
About these instructions
This instruction manual describes how to use the
multi-function ladder safely either as a stepladder, a
leaning ladder or as an extended ladder.
• Please read through these instructions before use
and retain them for future reference.
• This instruction manual must be included if you pass
on the ladder to someone else.
2
Intended use
This ladder is a piece of mobile work equipment that
can be used in different places.
This ladder allows users to perform small-scale
work at heights where the use of other equipment is
inappropriate (see German Ordinance on Industrial
Safety and Health).
This ladder may only be used in accordance with
these instructions. Any other use is considered
improper.
The manufacturer does not accept any liability for any
damage resulting from improper use.
Any modifications to the ladder that are not authorised
by the manufacturer will void the warranty and exclude
any liability of the manufacturer.
3
General safety instructions
In addition to the general safety instructions, users
must take note of the general markings on the product
(see "General markings" on page 9 ).
1. The ladder may only be set up and used by persons
familiar with these instructions for assembly and
use.
2. The ladder and its parts may not be modified.
3. Before using the ladder, check that all its parts are
assembled correctly and functioning properly.
8
4. When using the ladder, there is a risk of the user
8
falling from the ladder or the ladder toppling over.
8
This may cause injury to persons or damage to
8
property.
5. Make sure that the ladder is suitable for the
9
application in question and is set up in a proper
10
position during use.
6. The ladder should only be set up on an even,
10
horizontal and stable surface that can withstand the
10
load. Use load-distributing pads if necessary.
7. Do not move the ladder while standing on it.
11
8. When setting up the ladder, beware of the risk
11
of collisions, e.g. with pedestrians, vehicles or
doors. Whenever possible, lock any doors (except
emergency exits) and windows in the working area.
9. The ladder must be standing on its feet, not on its
rungs or steps.
10. Work involving the use of the ladder must be
carried out in a way that minimises the risk of the
user falling or the ladder toppling.
11. When using the product outdoors, take safety
precautions to protect it against the influence of
wind.
12. The ladder should only be used for performing
light work over a short period of time.
13. Fatigue while using the ladder is detrimental to
safety. Never work for long periods of time on the
ladder without taking regular breaks.
14. Only stand on surfaces intended to be stepped on.
15. Do not use the ladder if it is soiled (with e.g. wet
paint, dirt, oil or snow).
16. Do not use the ladder outdoors in poor weather
conditions, e.g. strong winds.
17. Never move the ladder holding the top.
18. Always use non-conducting ladders when you are
required to work around electricity.
19. To ensure the product is used properly, carry out
a risk assessment in accordance with the legal
requirements in the country of use.
20. The rules and regulations applicable in the country
of use must be observed especially when using
the product commercially.
21. Single or multiple joint ladders should be
unfolded/folded when lying on the ground and not
in its use position.