Cleaner Operation - Aqua Products EP37 Serie Mode D'emploi

1. Seat the control unit firmly in the control
unit base (Figure 1).
Figure 1. Connect Control Unit Base
2. Unscrew the protective cap for the
floating cable from the side of the control
unit by turning counter-clockwise (Figure
2).
Figure 2. Remove Protective Cap
3. Align the notch in the floating cable
connector with the key in the control
unit, engage then turn clockwise to
tighten (Figure 3).
Figure 3. Connect Floating Cable
4. Plug the control unit directly into a GFCI
outlet. DO NOT use an extension cord.
X
NOTE:
To avoid damaging the power cable, do not try
to twist the entire cable housing (see below).
X
"CLICK"
NOTE: To avoid exposing the power cable connector
pins to water, be sure the connector is screwed
in all the way and there is no gap. (see below).

Cleaner Operation

To prevent damage to the cleaner, be sure to adhere
to the following guidelines:
• Remove the cleaner from the pool after the
cleaning cycle is completed.
• Store cleaner out of direct sunlight out of direct
sunlight or inclement weather.
• Never lift the cleaner out of the pool by the
floating cable.
• Take additional care when lifting the cleaner
out of the pool. It becomes heavier when filled
with water.
• Always remove the cleaner from the pool before
super chlorinating or adding acid.
• Do not handle cleaner while it is in operation.
• Always make sure the cleaner head is fully
submerged before you begin operation.
• Clean the filter canister after each cleaning cycle.
• Do not leave your cleaner in the pool on a
permanent basis.
X
X
CAUTION
IMPORTANT
X
7
X
X