Important Safety Instructions - Aqua Products EP37 Serie Mode D'emploi

4

Important Safety Instructions

Congratulations on purchasing this Aqua Products Robotic Cleaner. Please
read through the entire manual before installing your new robotic pool
cleaner. Your cleaner must be installed and operated as specified.
Failure to comply with the following warnings can result in permanent injury, electrocution
or death.
PREVENT ELECTRICAL SHOCK
To reduce risk of electrical shock:
• Connect unit to receptacle protected by a ground fault circuit interrupter (GFCI). Such a GFCI
receptacle should be provided by a qualified installer and should be tested on a routine basis.
To test the GFCI, push the test button. The GFCI should interrupt power. Push the reset button.
Power should be restored. If the GFCI fails to operate in this manner, the GFCI is defective. If
the GFCI interrupts power to the pump without the test button being pushed, a ground current
is flowing, indicating the possibility of an electric shock. Do not use this product. Disconnect the
cleaner and have the problem corrected by a qualified service representative before using.
• Per the United States National Electrical Code
from the edge of the (pool/spa) water. In Canada, the Canadian Electrical Code (CEC) requires a
minimum distance of 3m (10 ft.) to be maintained between the pool edge and the control unit.
Never submerge the control unit.
• Do not enter pool while the Aqua Products cleaner is in water.
• Do not bury cord. Locate cord so as to prevent it from being damaged by lawn mowers, hedge
trimmers and other equipment.
• To reduce the risk of electrical shock, do not use the Aqua Products robotic cleaner or control
unit if the cord is worn or damaged. Contact Fluidra Technical Support immediately for proper
servicing and replacement of the damaged cord.
• Double insulation—For continued protection against possible electric shock, use only identical
replacement parts when servicing. Do not attempt repair of the Aqua Products robotic cleaner,
control unit, power cord, or floating cable.
• NEVER OPEN CONTROL UNIT.
• DO NOT USE AN EXTENSION CORD TO CONNECT THE UNIT TO ELECTRIC SUPPLY;
PROVIDE A PROPERLY LOCATED GFCI RECEPTACLE. THE CONTROL UNIT SHOULD BE
PLUGGED INTO THE GFCI RECEPTACLE BOX.
• PREVENT CHILD INJURY AND DROWNING
• To reduce the risk of injury, do not permit children to operate this product.
• Do not let anyone, especially small children, sit, step, lean, or climb on any equipment installed
as part of your pool's operational system.
WARNING
(NEC ), keep the control unit at least five (5) feet
® ®