Lionelo Theo Manuel De L'utilisateur page 6

There shall never be a gap between the lower side of the
7.
bedside sleeper and the mattress of the adult bed.
Check the tightness of the attachment system before each
8.
use by pulling the bedside sleeper in a direction away from
adult bed.
If there is a gap between the bedside sleeper and the adult
9.
bed DO NOT use the product.
Gaps should not be filled with pillows, blankets and other
10.
items.
DANGER! Always completely raise the drop side when not
11.
attached to the adult's bed.
WARNING: To avoid hazards from the child's neck being
12.
caught on the top rail on the side that is next to the adult bed,
the top rail must not be higher than the adult bed mattress.
WARNING: To avoid risk of your child being strangled the
13.
attachment system to the adult's bed shall always be kept
away from and out of the crib.
Installation instructions
1.
Combine both frame legs with a connection tube (fig. 1).
2.
The connectors have special screw holes. Use an Allen key to tighten the
screws (fig. 2).
3.
Connect the base frame with the gondola frame (fig. 3).
A.
Gondola
B.
Gondola frame connector
4.
Attach the front rail to the gondola frame, and then fasten the side zippers
(fig. 4).
5.
Press the height adjustment button and set a desirable height level. The
bed can be positioned in one of 5 height levels available. It is also possible
to set different height at each side (fig. 5).
6.
Press the button down and pull the leg out/in to adjust its length. There are
two positions available (fig. 6).
7. Moving the bed
Hold the back rail of the gondola, then lift and push it to move the bed. The rear
EN
C.
Height adjustment button
D.
Bed frame
‑ 6 ‑