CARVIN SHARK JET 1SHJ-5-S1 Manuel Du Propriétaire page 12

STRAINER NUT INSTALLATION
1.INSERTION
ALIGN MARKERS OF THE STRAIN-
ER NUT AND BODY AND INSERT.
REMOVING SPLASH COVER
1. REMOVING THE PUMP BASE
REMOVE SCREW AND SLIDE BASE BACKWARD .
THIS WILL DISENGAGE THE LOCKING TABS BLOCK-
ING THE SPLASH COVER.
DIFFUSER REMOVAL
M22904240B
(fig. 2)
(fig. 3)
(fig. 4)
INSERT A SMALL SCREWDRIVER
BETWEEN THE TWO SNAPS ON
THE MOTOR BRACKET.
SLOWLY THE DIFFUSER'S TAB TO
RELEASE. (REPEAT ON THE OTHER
SIDE)
WWW.CARVINPOOL.COM
2.TIGHTENING
2. REMOVING THE SPLASH COVER.
A. UNPLUG PUMP FROM POWER SOURCE
B. REMOVE THE TWO SCREWS HOLDING THE REAR
CAP
C. UNPLUG THE WIRES FROM THE SWITCH AND
REMOVE THE CAP.
D. TURN THE SPLASH COVER COUNTERCLOCKWISE
TO UNLOCK IT.
LIFT
TURN STRAINER NUT
1/4 TURN CLOCKWISE
TO TIGHTEN
COUNTERCLOCKWISE
TO UNLOCK
5