Samson Expedition XP312w Mode D'emploi page 16

Charging the Battery
The XP312w has an internal, rechargeable
battery capable of up to 12 hours of
continuous audio on a full charge. Even
though the system may have some charge
when first taken out of the box, it is
recommended to fully charge your XP312w
before first using the system.
To charge the battery:
1. Connect the XP312w to an AC power
outlet using the included power cable.
2. Set the power switch to the
"RECHARGE" position.
3. While charging the CHARGING
indicator will light red.
4. Keep the system plugged in until the
CHARGING indicator changes to green,
indicating the battery is fully charged.
If you find that the operation time of the
XP312w becomes noticeably decreased,
even after fully charging, the battery should
be replaced. Contact Samson customer
service or your local distributor for a
replacement battery.
A warning that batteries (battery pack or batteries installed) shall not be exposed to
excessive heat such as sunshine, fire or the like.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the
same or equivalent type. Attention should be drawn to the environmental aspects of battery
disposal
16