Samson Expedition XP312w Mode D'emploi page 12

Quick Start
1.
Set the XP312w power switch to the
OFF position, and fully turn all of the
LEVEL controls counterclockwise to 0.
2. If an outlet is available, connect the
included power cord to the AC input
of the speaker, and plug it into an
electrical outlet.
3. Set the XP312w power switch to the
ON position.
4. Connect your audio sources.
5. Turn the MASTER VOLUME control up
and set the input levels, following the
steps below.
Making Connections
Channel 1 (Microphone / Line Input)
1. Connect a microphone using a standard
XLR cable or line level equipment using
a 1⁄4" instrument cable.
2. If connecting a microphone, set the
LINE / MIC switch to the down (MIC)
position. If connecting a line level
device, set the LINE / MIC switch to the
up (LINE) position.
3. While speaking into the microphone or
playing music from a line level audio
source, slowly raise the CH1 VOLUME
control until you have reached the
desired level.
NOTE: If not using the Channel 1 input,
turn the VOLUME control all the way
down to keep out any unwanted noise.
Channel 2 (Aux Input)
4. Connect a line level device using 1⁄8"
cable.
5. While playing music from a line
level audio source, slowly raise the
CH2 VOLUME control until you have
reached the desired level.
12