Specifications - MTD Yard-Man YM155 Manuel De L'utilisateur

MOTOR OPERATES SLOWLY OR WILL NOT OPERATE
C A U S E
Battery is not charged
Overload protection switch has popped
BATTERY WILL NOT CHARGE
C A U S E
No power to charger or battery
Battery has failed
CUTTING ATTACHMENT WILL NOT ADVANCE LINE
C A U S E
Cutting attachment bound with grass
Cutting attachment out of line
Inner reel bound up
Cutting attachment dirty
Line welded
Line twisted when refilled
Not enough line is exposed
BATTERY AND MOTOR
Motor .................................................................................................................................................. 12 Volt DC, 15 Amps
Battery......................................................................................................................................... Sealed Lead-Acid, 12 Volt
Motor Wire Housing Tube............................................................................................................................ Aluminum Tube
Unit Weight (With battery, cutting attachment shield and D-handle) ...................................................... 10.2 lbs. (4.63 kg.)
Cutting Mechanism.............................................................................................................................................Bump Head
Line Spool Diameter...................................................................................................................................... 3 in (76.2 mm)
Trimming Line Diameter ......................................................................................................................... 0.080 in (2.03 mm.)
Cutting Path Diameter................................................................................................................................. 10 in. (254 mm)
TROUBLESHOOTING
Charge the battery
Reset overload protection switch
Check charger and charging station
Replace the battery
Stop the unit and clean cutting attachment
Refill with new line
Replace the inner reel
Clean inner reel and outer spool
Disassemble, remove the welded section
and rewind the line
Disassemble and rewind the line
Push the Bump Knob and pull out line until
4 inches (102 mm.) of line is outside of the
cutting attachment

SPECIFICATIONS

A C T I O N
A C T I O N
A C T I O N
15