Publicité
Les langues disponibles
Les langues disponibles
The angle of spray is smaller, but the water outlet
pressure is higher, and the material of surface to be
cleaned should be tough enough to support higher
pressure water.
Detail of intended use see items (1) ~ (4) below:
(1) Fine spot spray means delivering a high-pressure.
Pencil-point jet stream is used to wash heavy dirty
deposits in a small and concentrated area. It is ideal for
dissolving stubborn substances, like tar and grease spots
on concrete, or for removing caked mud from equipment.
It is also used to clean hard-to-reach areas including the
facades of 2-story buildings or undersides of lawn
mowers and tractors.
NOTE: Care should be taken when setting nozzle
spray to avoid permanently gouging wood or
damaging fragile surfaces.
(2) Setting to 15° or so fan spray for intensive cleaning
jobs on hard surfaces that can withstand the
high-pressure. Applications include stripping paint,
removing oil stains, grease, heavy mildew stains, and
rust from steel.
(3) Setting to 25°or so fan spray for cleaning home
siding, brick patios ,wood decks, driveways, sidewalks,
cars or furniture.
(4) Setting to 40°or so fan spray for cleaning items such
as cars, trucks, boats, patio furniture, or lawn equipment.
4.
When you finish your clean job turn the switch to "
OFF/O" position.
5.
Press the " test " button on the GFCI, and unplug the
power plug. This must be done each time the unit is in
maintenance.
6. Turn off the water supply.
7. After motor and water supply are turned off, trigger
spray gun to depressurize system.
8. Lock the trigger and put the spray gun, power cable,
detergent bottle and high pressure hose. ( Fig 11)
OPERATING
Fig. 11
CAUTION: NEVER using pressure washer after water
supply is turned off. Serious damage could occur to
the pump and /or motor.
WARNING:NEVER disconnect high pressure
discharge hose from machine while system is
pressurized. To depressurize, turn motor off, turn
water supply off and squeeze gun trigger 2-3 times.
9. After each use, wipe all surfaces of the pressure
washer with a clean and damp cloth.
TO WASH WITH DETERGENT
1. Fill it with a properly formulated detergent or cleaner
with a water ratio according to instructions on the
container. Connect nozzle to lance.
2. Squeeze the trigger, and detergent will come out
through the detergent bottle nozzle.
3.Apply detergent so it thoroughly covers cleaning
surface.
4. Allow detergent to remain on the surface for a few
minutes. This is a good time to use a brush to lightly
scrub heavily soiled areas.
5. Change to spray nozzle to rinse detergent from
surface.
6. Cleaning up: always draw fresh water through the
detergent bottle when done to flush any remaining
detergents from the injection system. The bottle could be
detached if necessary during this process.
7
PW190002
Publicité
