Télécharger Imprimer la page

Matco Tools MTCGLOWSPKR Mode D'emploi page 2

Publicité

Les langues disponibles

Les langues disponibles

Operations by ON/OFF BUTTON
- Press ON/OFF button to turn on the Vibe Speaker and lights. You will hear a tone/jingle and the light is in "Slow flash" mode
- Activate the wireless function on your device and select MTCGLOWSPKR to connect.
How to operate the ON/OFF switch
- Lightly press ON/OFF again and the light is in "Fast flash"
- Lightly press ON/OFF again and the light is in "Music flash"
- Lightly press ON/OFF again and the light will turn off but the music
continues to play
- Lightly press ON/OFF again and the light is in "Fast flash"
- The cycle repeats itself - To turn off the Vibe Speaker, press ON/OFF
for 5 seconds.
Connecting a wireless compatible device
- When the Vibe Speaker is in working mode,you can press ON/OFF switch at the
back OR to use a Remote Control to turn on the speaker and to activate the wireless
function on the mobile phone by connecting it to MTCGLOWSPKR.
- You will hear a tone/jingle when the wireless function is successfully connected.
Remarks
1. Disconnected prompt note : A tone/jingle
2. Maximum volume prompt note : A beep sound
3. Low battery prompt note : A low beep sound
4. Low battery power indication. When low battery power is detected, the "low battery" prompt note will prompt every 3 minutes. It will continue 3 times before
shutting down.
Remote control illustrations
Please pull away the PVC protection film from the battery before using the remote
control.
Troubleshooting
-If the Vibe Speaker does not turn on -The battery may have completely run out.
Connect the Vibe Speaker to a power source and wait for 30 minutes for the Vibe
Speaker to be partially charged.
-Volume too low -Increase the volume setting on the music source .e.g. mobile
phone.
-The recording may have lower volume. Try a different recording.
-The battery may be running low. Connect the power adapter to charge the battery
MTCGLOWSPKR
MTCGLOWSPKR
Distorted Sound
- The quality of the audio that you are playing affects the quality of the audio
the Vibe Speaker produces. The Vibe Speaker is a high-performance audio
reproduction system, a distortion that you did not hear before may become evident
in the Vibe Speaker.
- Changing your audio to a high quality file or format will allow you to hear a higher
quality signal.
- The Vibe Speaker cannot correct any deficiency in the audio source. - Lower the
volume on the source device and /or the Vibe Speaker
- Ensure the surface where the Vibe Speaker is sitting is not interfering with the
sound.
- The battery may be running low. Recharge the battery.
- Water may have seeped into the Vibe Speaker. Turn the Speaker upside-down
and let the water drain through the protective mesh.
Unresponsive to user input
If the Vibe Speaker becomes unresponsive to any user input ( does not turn off,
keys not responding, cannot stop or start audio streaming) let the Vibe Speaker
discharge its batteryand this will reset the device.
Important
If/when disposing of the Vibe Speaker, please obtain information on battery
disposal from your local authority.
RECYCLABLE
CORRUGATE BOX
2
12/22/20

Publicité

loading