Matco Tools MTCGLOWSPKR Mode D'emploi

BOCINA INALÁMBRICA CON ILUMINACIÓN VIBE
HAUT -PARLEUR SANS FIL LIGHT VIBE
WIRELESS VIBE
LIGHT SPEAKER
Charge before use.
WARNING
This product can expose you to chemicals including nickel, which is
known to the State of California to cause cancer and birth defects or other reproductive
harm. For more information go to www.P65Warnings.ca.gov.
Introduction
Thank you for purchasing the Matco Tools Vibe Speaker. This product is designed to provide high quality wireless sound for your
computer, phone, tablet or any other wireless compatible audio device. Please follow these instructions carefully as improper use of
the device can result in damage. Please read all safety and operating instructions thoroughly before installation and use and keep these
instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit.
Included
1. Vibe speaker
2. USB cable (no adapter)
3. Remote control
4. Instruction manual
Specifications
Power Adapter
Input
Speaker Output
Charging Time
Working Time
Battery
BT/Wireless Name
BT/Wireless Range
BT/Wireless Version
IP Rating
Also Available:
RS000482 - Charging Cord
MTCGLOWSPKR
AC 100 - 240V 50/60HZ
5V/1A
5W RMS
4 - 6 hours
Up to 8 hours
3.7V 4000mAH
MTCGLOWSPKR
10M Max
4.2
IP44 Waterproof
MTCGLOWSPKR
Warning
- Although the Vibe Speaker is IP44 rated the power supply is not.
It is recommended to charge the Vibe Speaker indoors.
If the Vibe Speaker malfunctions, switch it off, unplug the power
supply and contact your local authorized dealer.
The rated voltage of the device is 100-240V 50/60Hz. Please do not
exceed this voltage.
- Do not place the unit into water.
- Do not open or disassemble the unit.
- After charging, ensure the rubber seal cover is securely in place
before using the Vibe Speaker.
Charging
IMPORTANT : Before first use please allow the Vibe Speaker to
charge fully
- The POWER indicator is red while charging and turns green when
the battery is 90% or above 90% charged.
- The item comes with 1 piece of USB cable. Please use a suitable
AC100-240V, DC 5V,1A adaptor to connect to the power source.
Remarks : Depending on the model, you may charge the Vibe
Speaker by connecting the USB cable to a computer.
Copyright © Professional Tool Products, 2020
1
• Operating Instructions
• Warning Information
All rights reserved.
12/22/20