Matco Tools MTCWCS Mode D'emploi

CARGADOR DE TELÉFONO INALÁMBRICO CON BOCINA INALÁMBRICO
ENCEINTE SANS FIL AVEC CHARGEUR DE TÉLÉPHONE SANS FIL
WIRELESS SPEAKER WITH
WIRELESS PHONE CHARGER
Charge before use.
WARNING
This product can expose you to chemicals including phthalates,
which is known to the State of California to cause cancer and birth defects or other
reproductive harm. For more information go to www.P65Warnings.ca.gov.
Product Details:
* Input Voltage: DC 5V/2A
* Audio Output Power: 5Wx2
* SNR 90 db
* Wireless Charging Power: 5W
* Wireless Charger Output: 5V/1A
* Charging Time: 5 hours
* Play time: 5-7 hours
* Bluetooth Speaker: V5.0, 4Ω/5Wx2
* Built-in Batter For Speaker: 2500 maH battery
Operating Instructions:
Red indicator light will illuminate when the unit is
*
connected using either the DC 5V/2A adaptor or any other
mobile power source.
*
To charge your wireless enabled device, just place it on
the wireless charging panel.
* The device being charged must have wireless charging
capabilities in order to use the wireless charging panel.
* A blue indicator light will illuminate when the wireless
enabled device is being charged.
Music Playing in Bluetooth Mode:
*
Activate bluetooth mode by powering the product and
shifting the bluetooth swith to on.
Activate the bluetooth function in mobile device,
*
and pairing the
1.
Wireless Charger
Transmitter
2. Wireless Charger
Indicator
Also Available:
RS000473 - Replacement Charging Cord
MTCWCS
bluetooth name "MATCO59".
150 mm
Bluetooth Speaker 4.
3. MICRO USB
On/Off
MTCWCS MTCWCS
Safety Information:
Please read the safety instructions to prevent any dangerous situations
when using the product.
* Do not directly touch the over-heated panel of the product.
*
Do not place the product close to a heater, microwave oven, rice
cooker, pressure cooker or other heating devices.
* Do not violently drop or hit the product.
* Children should operate under Adult Supervision only.
* Do not operate in low temperature or himid environment. The normal
operation temperature is 32°-122°F .
* Do not place within 20 cm to medical equipment.
* Do not place foreign objects on Wireless Charging coil.
* Unplug the Wireless Charger when not in use.
FCC Warning:
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions:
a.) The device may not cause harmful interference.
b.) The device must accept, any interference received, including
interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment. This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. The
device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without
restriction.
Copyright © Professional Tool Products, 2020 All
1
• Operating Instructions
• Warning Information
rights reserved.
05/06/20