Publicité
MW SERIES INSTALLATION
• Install 5 grommet nuts into the front and rear of the enclosure as shown.
NOTE: MW series tops have 5 mounting holes. WMRK/ERK series tops have 4 mounting holes.
• Position the top as required. Thread all screws evenly then tighten the screws securely - do not
overtighten.
NOTE: For MW series top bonding, and the bonding of the two space panel to the MW top, see page 9.
Placing of the temperature sensor probe:
In order to achieve proper temperature sensing, the probe should be installed near the top of
the enclosure. The probe is provided with a 5' lead.
MW Series Fan Tops Only:
The aluminum access panel can be replaced
by any 2 space rack panel, including brush
grommet panel (Model No. BR2)
Fan type and quantity
depends on model
(10" fan top shown)
Front
Page 8
(FIGURE C)
FIGURE C
Top
Screw
Grommet Nut
Enclosure
Publicité
