Télécharger Imprimer la page

Publicité

Liens rapides

Integrated Thermostatic
THANK YOU
Thank you for purchasing an Integrated Thermostatic Fan Control Top.
Please read these instructions thoroughly before installing or assembling this product.
PRODUCT FEATURES
• Operates only when needed
• Reduces maintenance requirements
• Enhances reliability
Instruction Sheet
Fan Control Top
I-00111
Rev J

Publicité

loading

Sommaire des Matières pour Middle Atlantic Products ERK-10

  • Page 1 Instruction Sheet Integrated Thermostatic Fan Control Top THANK YOU Thank you for purchasing an Integrated Thermostatic Fan Control Top. Please read these instructions thoroughly before installing or assembling this product. PRODUCT FEATURES • Operates only when needed • Reduces maintenance requirements •...
  • Page 2 REGULATORY COMPLIANCE Federal Communications Commission (FCC) Compliance Statement CAUTION: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
  • Page 3 IMPORTANT SAFETY INSTRUCTIONS Safety Instructions - Rack Mount • Elevated Operating Ambient - If installed in a closed or multi-unit rack assembly, the operating ambi- ent temperature of the rack environment may be greater than room ambient. Therefore, consider- ation should be given to installing the equipment in an environment compatible with the maximum ambient temperature (Tma) specified by the manufacturer.
  • Page 4 IMPORTANT SAFETY INSTRUCTIONS • Keep these instructions • Heed all warnings • Follow all instructions • Do not use this apparatus near water • Clean only with dry cloth • Do not block any ventilation openings. Install in accordance with the manufacturer's instructions •...
  • Page 5 CONSIGNES DE SÉCURITÉ IMPORTANTES • Conservez ces instructions • Respectez tous les avertissements • Suivez toutes les instructions • Ne pas utiliser cet appareil près de l'eau • Nettoyer uniquement avec un chiffon sec • Ne bloquez pas les ouvertures de ventilation. Installer selon les instructions du fabricant •...
  • Page 6 THERMOSTATIC PROPORTIONAL SPEED FAN CONTROLLER Fan control module varies in fan speed based on tempearature, increasing fan life while decresing noise and power consumption. CAUTION: Placing Probe: To achieve proper temperature sensing,the probe should be installed near the top of the rack. The probe is provided with a 5’...
  • Page 7 THERMOSTATIC PROPORTIONAL SPEED FAN CONTROLLER SETTINGS • Remove the 2 nuts on unit’s mounting flange to access the jumpers on the module. CAUTION: Disconnect the power by removing the plug before removing the fan control assembly. ATTENTION Débranchez l 'alimentation en retirant la fiche avant de retirer l' ensemble de commande du ventilateur.
  • Page 8 MW SERIES INSTALLATION • Install 5 grommet nuts into the front and rear of the enclosure as shown. (FIGURE C) NOTE: MW series tops have 5 mounting holes. WMRK/ERK series tops have 4 mounting holes. • Position the top as required. Thread all screws evenly then tighten the screws securely - do not overtighten.
  • Page 9 BONDING THE MW SERIES TOP • Use the following factory-installed bonding stud to bond the MW top. (FIGURE D) Bottom View Top View FIGURE D BONDING THE MW SERIES TWO SPACE PANEL • Use a T-10 star wrench and the 2 provided 6/32 x 5/16 star screws to bond the two space panel to the top. (FIGURE E) FIGURE E Page 9...
  • Page 10 1. Install 4 grommet nuts into the front and rear holes of the enclosure as shown. (FIGURE F) do not overtighten 2. Position top as required. Thread all screws evenly, and then tighten screws securely - NOTE: For WMRK/ERK series top bonding, see page 11. ERK-10’ Shown Screw Grommet Nut Enclosure...
  • Page 11 Voice: 613-836-2501 - Fax: 613-836-2690 / ca.middleatlantic.com - customerservicecanada@middleatlantic.ca Factory Distribution USA: NJ - CA - IL Canada: ON - BC At Middle Atlantic Products we are always listening. Your comments are welcome. Middle Atlantic Products is an ISO 9001 and ISO 14001 Registered Company. Page 11...