Publicité
THERMOSTATIC PROPORTIONAL SPEED FAN CONTROLLER
SETTINGS
• Remove the 2 nuts on unit's mounting flange to access the jumpers on the module.
CAUTION: Disconnect the power by removing the plug before removing the fan control assembly.
!
ATTENTION
Débranchez l 'alimentation en retirant la fiche avant de retirer l' ensemble de commande
:
du ventilateur.
!
Mode 1: The Fan speed is proportional to the factory-set temperature.
Mode 2: Complete On (On or Off, is not proportional). This
mode is selected by removing a pluggable jumper on
the circuit board. (FIGURE B)
TEMPERATURE
A 3 position pluggable jumper (JP1, on circuit board)
is provided to adjust the temperature control range.
SLOW
Position 1
90°
Position 3
85°
Position 5
80°
SPECIFICATIONS
Power Input: 120VAC - 60HZ
Power Output: Fan cords (2 prong) outlets. Variable output,
30 to 120VAC @ 1 AMP
Protection: 2 AMP fuse
FULL SPEED
100°F
95°F (factory set)
90°F
Page 7
Remove for
Complete On Mode
TOP
FIGURE B
Temperature
Setting
Jumper
Rear of
Circuit
Board
Publicité
