Cleaning And Storage - Eurotops 48297 Mode D'emploi

EN
until the control lamp is green
again.
Use Without Attachment
(Picture C)
Move the steam brush in strokes over the
fabric and press the steam release but-
ton (7) at regular intervals as you do so. It
is important for the steam bottom (8) to
touch the fabric so that it is freshened up.
Use With Brush Attachment
(Picture D)
Move the brush attachment (4) in strokes
over the fabric and press the steam
release button at regular intervals as
you do so. It is important for the brush
attachment to touch the fabric so that it is
freshened up.
Use With Iron Crease Attachment
(Picture E)
Open the clip of the iron crease at-
tachment by pressing the lever slightly
towards the device. Clamp the fabric of
the item of clothing to be smoothed in
the iron crease attachment and let go of
the lever again. Slowly pull down the item
of clothing and press the steam release
button (7) at regular intervals as you do
so.
 
To generate a constant blast of
steam, the locking button on
the steam release button can be
pushed down. This keeps the
steam release button constantly
pressed down.
Bear in mind that delicate fabrics
must not be steamed with con-
stant steam.
Always release the locking button
before the device is switched off!
16

CLEANING AND STORAGE

Please Note!
■
Do not use any sharp or abrasive
cleaning agents or cleaning pads to
clean the device. These may damage
the surfaces.
• Regularly wipe down the housing with
a damp cloth and a little cleaning
agent if necessary. Then thoroughly
dry it.
• If necessary, brush fl uff and other con-
tamination off the attachments. The
attachments can also be rinsed with
water. Then dry them thoroughly.
• Empty the water tank (6):
1. Remove the water tank (see the
"Filling the Water Tank" chapter).
2. Pull the water tank cap (5) out of
the water tank, hold it over a sink
or similar outlet and turn it upside
down. Allow all the water to run
out of the water tank.
3. Reinsert the water tank.
4. Operate the device again for a
short time and press the steam
release button (7) to allow any
remaining amounts of water to
evaporate.
• Allow all parts to dry completely be-
fore storing them away.
• Store the device ideally disassembled
in a clean, dry place so that it is pro-
tected from sunlight and is out of the
reach of children and animals.