Accessories; Mounting/Removing Attachments - Eurotops 48297 Mode D'emploi

EN
■
Do not operate the device in the
vicinity of combustible material.
■
Always place the device upright on
the water tank even during short
pauses. Pull out the mains plug during
longer pauses.
■
Immediately after smoothing, place
the still hot device down a minimum
distance of 15 cm away from walls,
furniture and other objects.
■
Never cover up the steam nozzles and
do not insert any objects into them.
NOTICE – Risk of Damage to
Material and Property
■
Only connect the device to a plug
socket that is properly installed and
matches the technical data of the
device. The plug socket must also be
readily accessible after connection so
that the connection to the mains can
quickly be isolated.
■
Never direct the steam directly at the
connecting cable or parts containing
electrical components (such as inside
ovens, fridges, at switches and lights,
microwave ovens).
■
Never exceed the maximum fi ll level
to prevent overfl owing (note the max
marking on the water tank!).
■
Only activate the steam release but-
ton when the water tank is fi lled with
water as otherwise the water pump
may be damaged and the useful
service life of the device may be
shortened.
■
Make sure that the connecting cable
is not squashed, bent or laid over
sharp edges and does not come into
contact with hot surfaces (e.g. of the
device).
■
Always switch off the device fi rst be-
fore the plug is pulled out of the plug
socket. When you pull it out of the
plug socket, always pull on the mains
plug and never the mains cable.
14
■
Switch off the device and pull the
mains plug out of the plug socket
if an error occurs during operation,
when there is a power cut or before a
thunderstorm.
■
Never pull or carry the device by the
connecting cable. !
■
Protect the device from other heat
sources, fi re, persistent moisture, wet
conditions and impacts.
■
Use only original accessories from the
manufacturer in order to guarantee
that there is no interference that may
prevent the device from working and
to avoid possible damage.
■
Use and store the device at room
temperature, do not expose it to
extreme temperatures or temperature
fl uctuations.

ACCESSORIES

• The brush attachment (4) is suitable
for freshening up home textiles such
as upholstery, curtains etc. (Picture D).
• The iron crease attachment can be
used to make creases, e.g. in trousers
and skirts. In addition, it is suitable for
smoothing clothing (e.g. made from
linen, cotton, polyester etc.) (Picture E).
MOUNTING/REMOVING
ATTACHMENTS
Please Note!
■
Shortly after use, the attachment
used may still be very hot. Wait until
the device and the attachment used
have cooled down completely before
removing them.
• Attaching: Place the attachment with
the locking lug at the top or bottom
on the steam bottom and press it
fi rmly downwards or upwards. The