Sunred SFT15 Serie Mode D'emploi page 18

EN
ASSEMBLY
Step 12
Connect gas hose with burner.
Ensure tight position.
Run a tightness/leak test.
The injector attached to this unit is not intend-
ed for removal. The injector is factory assem-
bled. It is forbidden to change this device from
one gas pressure to another pressure. Do not
connect gas cylinder directly to the unit with-
out a regulator.The flexible hose should be
approved according to EN16436:2014. The
regulator must comply with standard
EN16129:2013, the outlet pressure of the
regulator should correspond to the values on
the nameplate. The replaced regulator must
comply at least with the following specification
according to national regulations.
Step 13
Insert housing door J and close the
door.
17