Sunred SFT15 Serie Mode D'emploi page 15

EN
ASSEMBLY
Step 4
Slide the reflector plate onto reflec-
tor panels. Insert one Bolt GG. Slide
one washer FF over threaded end of
Bolt M6x10 II and screw one cap nut
HH loosely. Repeat procedure to
complete the assembly of all three
sections. Fully tighten all of the volts
in the rolled edge.
Step 5
Assemble reflector A. Connect three
reflector parts with middle ring. Use
screws GG, washers FF and cap nuts
HH.
Step 6
Insert glass piston E. The rubber ring
faces downward.
Step 7
Fix the upper Plate on the four
brackets supported by screws AA.
14