Sunred SFT15 Serie Mode D'emploi page 14

ASSEMBLY
Step 1
Mount the wheel assembly on the
base plate. Fasten the wheel assem-
bly to the base plate using 8 M6X12
bolts BB and 8 m 6 flange nuts CC.
Insert the pins of the base into the
holes of the lower bracket and press
to secure the pins.
Use 4 M5X12 screws LL to secure
the lower support and lower frame.
Insert the pins of the control unit
into the holes of the upper bracket
and press them to secure the lower
support and lower frame. Inser the
pins of the control unit into the
holes of the upper bracket and
press them to secure the pins. Use
the 4 piece screw M5X12 screw LL
for fastening.
Fasten the magnets PP with the
screws M3x9 MM and the flange
nut M3 NN.
NOTE
The top frame must match the bottom
frame. The magnet side must be on the
same side as the grooved side.
Step 2
Screw the side panels together with
the 18 screws M3x15 AA.
Step 3
Insert the 4 upper aluminum pro-
files into the holders provided on
the firing unit and screw them to-
gether with the M3x16 screws AA.
Unscrew the switch button, insert a
small battery (not included), tighten
the switch button.
EN
13