Publicité
Les langues disponibles
Les langues disponibles
S S e e r r v v i i c c e e
A A r r m m c c a a p p r r e e p p l l a a c c e e m m e e n n t t
T T o o o o l l s s r r e e q q u u i i r r e e d d : :
•
Rubber hammer
•
Large flat screwdriver
P P r r o o c c e e d d u u r r e e : :
1. Using a rubber hammer, hit the back of the arm cap (A) toward the front of the glider until it stops moving forward (Figure
2).
N N o o t t e e - - Use caution when you hit the arm cap to avoid the risk of damage to the fabric.
2. Position a large flat screwdriver between the arm cap and arm to pull up on the arm cap and loosen the arm cap from
the glider. Remove and discard the arm cap.
3. Align the new arm cap bolts with the holes at the front of the arm slots.
4. Using a rubber hammer, hit the arm cap down until it is tight to the arm.
5. Using a rubber hammer, hit the arm cap toward the back of the glider until it stops moving back.
N N o o t t e e - - Use caution when you hit the arm cap to avoid the risk of damage to the fabric.
6. Verify proper operation before you return the product to service.
S S e e a a t t c c u u s s h h i i o o n n r r e e p p l l a a c c e e m m e e n n t t
T T o o o o l l s s r r e e q q u u i i r r e e d d : :
•
#3 Phillips screwdriver
•
Blanket or equivalent
P P r r o o c c e e d d u u r r e e : :
1. Lay a blanket, or equivalent, on the floor behind the glider.
2. Using two hands, lift up on the bottom of the glider to flip the glider onto its back.
C C A A U U T T I I O O N N - - Always use two people when you lift or move the product. Always confirm stable foot placement and back
support to avoid the risk of injury or product damage.
3507009001-A
A
F F i i g g u u r r e e 2 2 – – A A r r m m c c a a p p
9
EN
Publicité
