Gamma Piu X-ERGO Notice D'utilisation Et Garantie page 13

• Make sure that the mains voltage matches the one shown on the technical data
plate on the appliance and on the feeder.
• The appliance can be used by children from 3 years of age under supervision.
• This appliance can be used by children starting from the age of 8 and by people with
reduced physical, sensory or mental capabilities, or by people lacking the experience
or knowledge, as long as they are properly supervised and instructed on the use of
the appliance and are involved in the comprehension of the dangers.
• Children must not play with the appliance.
• Cleaning and maintenance must not be performed by children without supervision.
• To guarantee the proper and safe functioning, should the device fall or impact
violently, have it checked at an authorised customer service centre.
• The power cord must never come into contact with the appliance.
• Always disconnect the appliance after use.
• Use, charge and store the appliance at a temperature between 0 °C and 40 °C.
This appliance is designed for professional use in commercial areas.
DESCRIPTION OF THE APPLIANCE AND ITS
ACCESSORIES
Make sure your appliance is provided with the correct accessories (fig. 1 - 3 - 4 - 5).
A Cutting head
B On-Off switch with LED
C Power supply socket outlet
D Lever to adjust the cutting height
E Screwdriver for body screws
CHARGING THE APPLIANCE
• Ensure that the appliance is completely dry.
• Ensure that the appliance is off, or turn it off by pressing the switch B (fig. 1).
This appliance can be used on battery power or connected directly to
the mains power supply.
Do not completely discharge the battery in case you wish to use the
appliance with the power supply cable inserted.
Do not recharge the appliance if the ambient temperature is below 0 °C or
above 40 °C.
Recharge the appliance the first time it is used and whenever the LED starts flashing,
indicating that the appliance is charging.
The appliance can be charged by connecting the feeder directly to the appliance or
by connecting it via the base I (fig. 1).
1) Direct connection: connect the feeder connector F (fig. 1) to the port at the
bottom of the appliance C (fig. 1).
2) Connection through base: insert the appliance into the base H (fig. 1) and the
feeder F (fig. 1) into the port at the bottom of the base.
3) In both cases, connect the other end of the feeder to the mains power supply.
F AC/DC feeder with power cable
G Guide combs
H Charging base
I Lubrication oil
L Brush
13