Storage; Technical Data - Deltafox DG-CHT 1845 T Set Traduction De La Notice D'utilisation Originale

• Before each use, check the hedge
trimmer for obvious defects such as
loose, worn or damaged parts. Check
the secure seating of the bolts in the
cutter bar.
• Check coverings and safety devices
for damage and correct seating. Re-
place these where necessary.
• Keep the ventilation slots (
motor housing (cutting head) (
of the device clean. Use a damp cloth
or a brush to do this. Do not wash
down the equipment with water, or
submerge it in water.
• Always keep the equipment clean.
After using the equipment, it is im-
perative to:
- Clean the blade
(with an oily cloth);
- Oil the blade shaft
with an oil can or
spray.
• Slight notches on the blades can be
evened out. For this, sand down the
blades with an oil stone. Only sharp
blades can cut properly.
• Blunt, bent or damaged blades must
be changed.

Storage

• Keep the trimmer in the blade guard
supplied, in a dry place and out of
reach of children.
• Store the unit horizontally or assured
against falling over. Bring the cutting
unit in storage location.
• Store the battery only in a partially
charged state. During prolonged
storage, 2 to 3 LEDs should be illumi-
nated.
• Store the equipment between 0 °C
and 45 °C. During storage, avoid
extreme cold or heat so the battery
does not lose power.
• During a longer storage period, check
the state of charge of the battery and
recharge if necessary roughly every
3 months.

Technical Data

Cordless telescopic
hedge trimmer ........ DG-CHT 1845 T Set
3) and
2) .........................................DG-CHT 1845 T
Motor voltage .............18 V (max. 20 V)
Blade speed.................... 1200 min
Protection class ......................................III
Weight
(without battery and charger) ..... 3.15 kg
Blade length..................................450 mm
Cutting length ...............................410 mm
Cutting capacity ..............................16 mm
Sound pressure level
(L ) ..................... 77,9 dB(A), K
pA
Sound power level (L
guaranteed ...............................91 dB(A)
measured ..........89 dB(A); K
Vibration (a
Rear handle.............................2.69 m/s
Front handle ............................3.04 m/s
Noise and vibration values have been de-
termined according to the standards and
regulations mentioned in the declaration of
conformity.
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to com-
pare one power tool to another. The stated
vibration emission value may also be used
for a preliminary exposure assessment.
)
WA
)
h
Warning:
During actual use of the power tool,
the vibration emission value may
differ from the value specified, de-
pending on the manner of use of the
power tool.
GB
(rpm)
-1
= 3 dB
pA
= 2.19 dB
WA
2
2
K=1.5 m/s
2
59