Momentum PakYak Manuel De L'utilisateur page 4

- All four PakYak Passenger accessories (Bar, Seat Pad, Foot Rest &
Wheel Guard) MUST be used in conjunction with one another other to
safely transport passengers on the PakYak E+.
- If you are not confident with installation of this product, please consult
your local authorized dealer.
- Regulation can vary by country, and/or location, always check in
advance.
Installation
1. Ensure the bike is switched off with kickstand engaged and is on level
ground.
2. Remove any accessories that may interfere with the installation and/or
use of the PakYak Passenger Foot Rest.
3. Start by identifying the RIGHT-side and LEFT-side foot rest.
4. Attach RIGHT PakYak Passenger Foot Rest to right side of frame using
the three bolts and partially tighten them.
5. Check that PakYak Passenger Foot Rest is secure against frame at
each mounting point.
6. Use a 6mm hex torque wrench for M8 bolt with 12Nm and 5mm hex
torque wrench for M6 bolt with 10Nm to tighten each bolt .
7. Double check if the PakYak Passenger Foot Rest is properly installed.
The PakYak Passenger Foot Rest should not move or rotate in any
direction.
8. Repeat this process on the LEFT side by following steps 1 to 7.
Usage information
Suitable for (recommended):
• Age: 5 years and up
• Body weight: 44lbs/20kg and up
• Body Height: 3'6"- 4'7"/110-140cm
- It may be illegal to carry passengers on a bike in your area even if it has
been designed or configured to do so. Check your local regulations
before carrying passengers.
- The main rider and passenger(s) are strongly advised to wear a quality
protective helmet while riding. Consult your local regulations before
riding or carrying passengers.