Dremel 7300PT Mode D'emploi page 3

DM 2610011823 04-10:DM 2610011823 04-10 4/2/10 10:13 AM Page 3
For pets with particularly long hair, use an old sock
to cover the toe, foot and leg of the pet and isolate
the nail. Push the nail out through a small opening at
the tip of the sock to groom the nail.
Set the speed indicator to fit the job to achieve the
best job results when working with different
ma te rials.
To select the right speed for each job, use a prac-
tice piece of material. Vary speed to find the best
speed for the accessory you are using and the job
to be done.
On the Model 7300PT, there is a LO and HI switch.
When the switch indicator is in position 1 or LO, the
tool runs at about 6,500 RPM. When the switch
indicator is in position 2 or HI, the tool runs at about
13,000 RPM.
NOTE: Speed is affected by voltage changes.
Weaker batteries with reduced voltage will slow the
RPM of the tool, especially at the lowest setting. If
your tool appears to be running more slowly than
normal, replace the batteries with fresh ones to
increase tool speed.
Most applications using the 7300PT Pet Nail
Grooming Tool can be accomplished using the LO
speed setting (position 1). The LO speed setting
(position 1) is recommended when using the 431
Operating Speeds For ccessories
Keep styptic powder on hand in case of bleeding.
Styptic powder is available at most pet supply
stores. Follow the directions on the packaging for
proper use instructions.
sanding drum included with the tool. HI speed is
needed only for larger animals or nail buffing appli-
cations.
The speed of Model 7300PT is controlled by
setting this indicator on the housing.
3