Lionelo Astrid Manuel De L'utilisateur page 15

Hold the carrier with one hand and pull the covering with the other in the direction
showed by the arrow in the fig. 33.
When you can see free space between the carrier covering and harness adjustment
belt (F), pull the covering upwards so that it goes through the adjustment belt (fig. 34).
How to assemble the covering and sunshade
•
Covering
Put the covering on the carrier. Pull the crotch belt through a protective cushion of
this belt (fig. 35). Pull the belts through holes in the covering (fig. 36). Pull the harness
adjustment belt through the dedicated hole on the covering (fig. 37). Smooth the
covering away so that it fits the carrier properly. Stretch and fix the covering on ends
of the carrier then slide the belt guides (K) into position (Fig. 38 and 39). Set the
handle in the A position (fig. 7). Fasten clips on both sides of the covering (fig. 40). Set
the handle in C position (fig. 7). Slide the plastic cover hooks into place (figure 27).
•
Sunshade
Insert the brackets in the corresponding place on the casing. Apply the canopy
to the casing of the baby carrier (fig. 41). Then slide the rubber hooks of the
sunshade onto the plastic cover (fig. 27).
Take the sunshade out and set it in a desired position.
How to clean and maintain
•
Check the product for potential damage on a regular basis. If the carrier
was affected during an accident, it must be replaced by a new item, even
if you cannot see any damage with a naked eye. Do not use greases.
When you do not use the product, keep it away from sunlight.
•
The covering can be removed for cleaning purposes. You can wash it manually
at the temperature up to 30˚C. Do not use strong detergents (e.e. solvents).
•
The belts, protective cushions and buckles must be washed with water and soap.
The pictures are for reference only. The real design of the products may differ
from the pictures presented.
‑ 15 ‑ EN