Dake Capa Instructions De Montage page 40

en
3. Now transfer the suspension holes on
the hood upper part onto the ceiling
(dimensions vary depending on the
model size), drill the holes, fit the correct
dowels and tighten the hanger bolts.
4.
Before hanging the upper part of the
Capa hood, check that the exhaust air
connection is facing to the correct side!
Now push the suspension holes in the
upper section onto the hanger bolts in
the ceiling. Tighten the bolts with the
large washers and nuts supplied.
5.
Now create the exhaust air connec-
tion between the exhaust air duct/hose
and connecting piece. In the case of
existing false ceilings, the connecting
piece may be removed.
40
6.
Now introduce the supply line via the
cable passages on the upper part.
7.
Screw the hood lower part to the
hood upper part (as described under
point 2. but in reverse sequence). Com-
plete the electrical connection.
8. Now conduct a function test.
Disposal Packaging
The appliance packaging is recyclable.
Cardboard and polyethylene film (PE)
are used as packaging material. These
materials must be disposed of in an
environmentally friendly manner and in
accordance with the currently valid on-
site regulations.
Environmental Information
This appliance is labelled in accordance
with European Directive 2002/96/EG
conceming used electrical and elec-
tronic appliances (waste electrical and
eleclronic equipment - WEEE). The
guideline determines the framework for
the return and recycling of used appli-
ances as applicable throughout the EU.
Please ask your dealer about current