Dake Capa Instructions De Montage page 36

en
5. Before using a lift to hang the extrac-
tor hood, you must remove the metal
filters. To do this, use both hands to pull
down the metal filters until the magnet
contact releases. Then release the
locking hook on the metal filters.
6. Then raise the extractor hood using
the lifting device (make sure it is facing
the correct way) to a distance of approx.
30 cm from the ceiling. At this point,
connect the hood to the power supply.
Pay attention to the area on the ceiling
in which the electrical supply line can be
routed!
7. Now unscrew the securing bolts (E)
on the hood upper section (B) while
holding the hood lower section (D) with
one hand.
8. Lift up the extractor hood with 2 men
(3) Make sure that the fastening screws
are fitted into the "pear-shaped holes"
on the top of the extractor hood (3).
Then push the extractor hood back-
wards (4) to lock it in position.
36
Ansicht von oben