Power On A Device That Uses A Standard Power Adapter - Linksys WAPPOE Mode D'emploi

Chapter
Power on a Device that Uses a Standard
Power Adapter
Use the Injector and Splitter to power up a device that uses a standard
power adapter. Follow these instructions:
1. Connect the Injector's built-in Ethernet network cable to your router,
switch, or other network device.
2. Connect the Kit's included Ethernet network cable to the Injector's
Power & Data OUT port.
NOTE:
own Ethernet network cable.
3. Then connect the other end to the Splitter's Power & Data IN port.
4. Connect the Splitter's built-in Ethernet network cable to the Ethernet
port of your remotely located access point or other network device.
5. Connect the Splitter's Power cord to the Power port of your remotely
located access point or other network device.

 
If this cable is not long enough, then you can use your
Connection
PowerOverEthernetAdapterKt