GE Prolife PDW8700 Serie Manuel page 4

About the dishwasher control panel.
You can locate your model number on the tub wall just inside the door. Throughout this manual, features and appearance may vary from your model.
PDW8700 Series and PDW8800 Series
G LASSES
PDW9200 Series
A B
NTI- ACTERIAL
C
OOKWARE
N ORMAL
PDW9800 Series
A NTI- B ACTERIAL
C
OOKWARE
N
ORMAL
2
1
Status Indicator Lights
The Status display tells you what is happening while the dishwasher is in operation and may flash,
indicating a malfunction. The lights will come ON indicating the sequence of the dishwasher operation.
ADD-A-DISH Displayed during prewash indicating that dishes added now will still be cleaned.
2
Time Remaining Display
During operation, the display shows the minutes remaining until the cycle is complete. The display may
adjust the remaining time while the Sensing light is on. The time displayed at the start of each cycle may
change from the factory setting as the unit customizes itself to home use. During a delay start, the
display will show hours of time remaining until the cycle starts.
3
Selections
PDW8700 Series and PDW8800 Series: Press the pad for the desired wash cycle.
PDW9200 Series and PDW9800 Series: Use the Arrow Pads
NOTE: All cycle times and water usage information contained in the following section are approximate values only. Actual
results will depend on several factors, including but not limited to, inlet temperature, household water pressure, and turbidity
of the wash water.
The light above or next to the selected pad will be ON to indicate which WASH CYCLE has been selected.
ANTI-BACTERIA Heavy 7.8 gal., 105 min., Medium 6.7 gal., 95 min., Light 5.6 gal., 85 min.
4
1
SENSING ADD-A-DISH WASHING DRYING SANITIZED
C HINA
C
RYSTAL
3
C C
HINA RYSTAL
R O
INSE NLY
3
S PEED C YCLE P LASTIC C YCLE
C C R O
HINA RYSTAL INSE NLY
G
LASSES
3
(Indicators vary by model)
SENSING Displayed while the Clean Sensor
The dishwasher will adjust the selected cycle to achieve optimal performance.
WASHING Displayed during prewash, main wash and rinse periods.
DRYING Displayed during HEATED DRY.
SANITIZED Displayed when cycle has met sanitization conditions.
CLEAN Displayed when a wash cycle is complete.
(on some models)
This cycle raises the water temperature in the final rinse to sanitize your dishware. The cycle length will
vary depending on the temperature of your inlet water.
NOTE: The Anti-Bacteria cycle is monitored for sanitization requirements. If the cycle is interrupted
during or after the main wash portion or if the incoming water temperature is so low that adequate
water heating cannot be achieved, the sanitizing conditions may not be met. In these cases, the
sanitized light will not illuminate at the end of the cycle.
NOTE: NSF-certified residential dishwashers are not intended for licensed food establishments.
6
CLEAN
5 4
4
4
™ is measuring the amount of soil and temperature of water.
2
1
S ANITIZED
C LEAN
6 5
1
S D
ENSING RYING
A A-D S
DD- ISH ANITIZED
W ASHING C LEAN
6
to scroll through the wash cycles.
5