HQ Power VDPDMXBAR2 Manuel page 3

• UP BUTTON
Press this button increase the DMX address to a maximum of 512.
This function is not available in Master Mode.
• DOWN BUTTON
Press this button to decrease the DMX address with a maximum of 512.
This function is not available in Master Mode.
• F + ~ BUTTON (press F and ~ at the same time)
Press to select L- - or R- -.
NOTE:
L- - refers to data information of CH1, CH2, CH3 and CH4 corresponding to outputs 1, 2, 3 and 4.
R- - refers to data information of CH1, CH2, CH3 and CH4 corresponding to outputs 1, 2, 3 and 4.
• F + D/S BUTTONS
Press to select CRO or NOR.
NOR refers to 0 – 100% dimming.
CRO indicates that only FULL ON and STAND BY are available. When the dimming level is higher than 50%
FULL ON will be activated, otherwise STAND BY will be activated.
• F + MODE BUTTONS
This function is only available in MASTER mode.
• F + PRESET BUTTONS
Press F + PRESET to select an available parameter, adjust the selected parameter using the UP and DOWN
buttons.
PARAMETER
F 00 – F 99
D 00 – OFF
R 01 – R 99
E 00 – E 25
• F + SIGNAL SELECT BUTTONS
Press to switch the operating mode from DMX to MASTER; the DISPLAY will show OUT.
• F + SIGNAL SELECT + RESET BUTTONS
Press this combination to reset the whole system, which enables you to return to the initial settings.
• The DMX indicator blinks when preheating function is active, it will light otherwise.
• The SIGNAL indicator blinks when a DMX signal is available and goes out when it is not available.
• The DISPLAY shows IN and the channel indicators will stop blinking after 10 seconds when operation is
paused.
b. MASTER mode
When the MASTER indicator is on (press F + SIGNAL SELECT until the DISPLAY shows OUT), this unit is being
used as a DMX chase controller.
VDPDMXBAR2
FUNCTION
Fade time (0 – 10s)
Dimmer (0 – 100%)
Speed (1/60 step per second to 20 steps/second)
Preset minimum dimming level (0 – 25%)
3 VELLEMAN