AgfaPhoto AF5078PS Mode D'emploi page 9

Safety Instructions and
Recommendations
Do not make any changes or settings that are not Introduction 2
described in this u ser m anual. Physical i njury or
damage to the devi ce or los s of d ata ca n r esult
from improper handling. Take note of all wa rning
and safety notes indicated.
Setting Up the Device
The device is exclusively for indoor use only. The The device is exclusively for indoor use only.
device should rest sec urely on a stabile, flat sur -
face. Position all cables in such a way that no one
will stumble on them, thus avoiding possible inju-
ries to persons or damage to the device itself.
Always handle the unit with care. Avoid touching
LCD screen
the LCD sc reen. Never pl ace heavy o r sha rp ob-
jects on the LCD panel, frame or power cord.
Protect the device ag ainst d irect su nlight, heat, Protect the device against direct sunlight
large tem perature f luctuations and moisture. Do
not place the device in the vicinity of heaters or air
conditioners. Observe the information on temper-
ature and humidity in the technical data.
The device should not be switched on immediately
Do not switch the device on immediately after transporting it.
after being moved from a cold to a warm room or
vice versa or into a cold room which has been
heated up qu ickly. In such cas es, wait at least
three hours unti l the devi ce has adapted to the
changed conditions (temperature, humidity...) .
In the event that the device becomes too hot, or if
In the event that the device becomes too hot, or if you see smoke coming from the device
you see smoke coming from the device, you must
immediately pull the power cable out of the power
socket. Have your device examined by trained pro-
fessionals at a technical service location. To pre -
vent the spread of fire, open flam es should be
kept away from the device.
Do not p lug in the d evice in m oist rooms. Never
Do not plug in the device in moist rooms.
touch the mai ns c able or the ma ins c onnection
with wet hands.
Do not allow liquids to enter into the device. Dis- Do not allow liquids to enter into the device.
connect the devi ce from the power socket if liq-
uids or f oreign ob jects have ent ered the d evice
and have your device examined by trained profes-
sionals at a technical service location.
Do not allow children to handle the device without
Do not allow children to handle the device without supervision.
supervision. The packing materials should be kept
out of the hands of children.
Power Supply
Use only the enclosed power adapter ( s ee chapter Use only the enclosed power adapter
Appendix / Tec hnical Data ). Ch eck wheth er th e
mains voltage of your devi ce (i ndicated on the
type label) matches the mains voltage available at
the setup location. This equipment complies with
the voltage type specified on the unit.
Never touch the power c able if the insu lation is
Never touch the power cable if the insulation is damaged.
damaged. Repla ce damaged wi res immediately.
Use suitable cables only; if necessary please con-
tact our technical customer service or your retail-
er.
Before cleaning the surf ace of your device, dis-
Before cleaning the surface of your device, disconnect it from the power network.
connect it from the powe r netw ork. Use a soft,
lint-free cloth. Never use liquid, gaseous or easily
flammable cleansers (sprays, abrasives, polishes,
alcohol). Do not allow any moisture to reach the in-
terior of the device.
Only clean the display with a dry, soft cloth. If the
Only clean the display with a dry, soft cloth.
display breaks, a mildly corrosive li quid may es-
cape. Avoid all contact with your skin and eyes.
Repairs
Do no t make an y repairs to the devi ce yourself. Repairs
Improper m aintenance c an result i n i njuries or
damage to the device. O nly have your devi ce re-
paired by an authorised service centre.
Do n ot remove th e type label fr om your device;
this would void the warranty.
Photo Memory Media
Only use storage m edia that are com patible with
Photo Memory Media
the device. In order to prevent damage to the card
or the unit, please tu rn off the pow er before re-
moving or inserting the card.
Never pull out the memory card while the device is
accessing it. This could cause data to be damaged
or lost.
EN
1