Table des Matières
Publicité
7. Release Film Instructions
a.
b.
c.
Installation steps
a.
First, remove the 14 screws at the bottom of the vat and take
down the old release film.
Prepare the new release film, peel off the the protective films
b.
on both sides of the release film. Align the holes and fit the
release film on the clamping ring.
c.
Finally, place the film-ring assembly back into the vat frame
gently, then intall and tighten the fixing screws diagonally.
The installed release film is as shown.
d.
d.
Parameters
Size： 190mm*266mm
Thickness： 0.15-0.2mm
Light Transmittance ： 95%
36
Publicité
Table des Matières
