Thankyou for purchasing a Herschel Select XLS infrared towel heater. Incorporating the very latest in control with
its inbuilt touchscreen and app control and its EASYFIX mounting and slimline frameless design, you will enjoy
many years of low energy, smart and comfortable heating.
We've tried to make installing and using your heater as easy as possible. Please read these instructions fully and
retain for future reference. If you have any questions our website also has many FAQs or you can call, message
or online chat with us, we are always happy to help ensure that you get the most from your new Herschel
heating system.
Positioning
WARNING
Herschel Select XLS towel heaters are rated to a standard (minimum IP44) enabling them to be located within
zone 2 in a bathroom. This means they can be placed 60cm outside any splash zones. They cannot be installed in
zones 0 or 1 (see diagram).
However, installation in potentially wet or humid rooms such as bathrooms must be carried out by a suitably
qualified installer and comply with local electrical safety requirements. Installation must be such that the heater
must not be able to become detached from the fittings and fall into a bathtub, shower, swimming pool or other
water container and that switches and other controls cannot be touched by a person in the bath or shower.
If in doubt, do not install. Herschel Infrared Ltd shall not be liable for any loss, daage or injury caused or
resulting from inadequate fitting or incorrect placement of heaters close to water sources.
Select XLS Towel heater
The heater must be wall-mounted only in a
portrait position.
Leave 200mm to each side and the bottom
of the heater, clear of other objects (floor,
furniture etc.)
The top portion of the towel heater is
hotter than the lower portion. This part of
the heater is designed to heat the room, so
you should avoid placing the heater where
obstacles could obscure this part of the
heater.
The lower portion of the heater is a cooler
portion designed just to dry and warm your
towels.
ENGLISH