Removing The Purifier Plate & Activepure ® Cell - vollara AIR & SURFACE PRO+ Mode D'emploi

REMOVING THE PURIFIER PLATE & ACTIVEPURE
CAUTION
WARNING
NOTE: Use genuine Vollara replacement parts only. Parts from anyone other than Vollara may damage your unit and void your
warranty.
1. To remove the Purification
Plate, grasp edge of plate
in the center and gently
pull out. .
If the plate is difficult to
NOTE:
remove, gently press
down on the lower
metal contact tab.
4. Remove two
(2) thumbscrews.
Do not look directly at the glowing lamp. Prolonged exposure, even to reflected UV light,
can cause eye damage according to the American Conference of Governmental Industrial
Hygienists (ACGIH) Standards.
• Unplug the unit before performing any maintenance procedures
• Do not operate the Vollara® Air & Surface Pro+ without the Filter Assembly and Back Cover
properly installed
2.
5.
Unlock the ActivePure®
Cell connector by
pressing on the
connector's locking tabs.
Slide the
ActivePure® Cell
down and out of unit.
CELL
®
3. Pull the connector
straight out to unplug.
11