Publicité
Les langues disponibles
Les langues disponibles
9. Battery
•
When the battery indicator [B] indicates low battery, replace the batteries with new ones.
•
Switch the microphone off [A].
• Open the battery compartment by sliding the plastic battery cover [D] away from the microphone head [C].
• Insert a new 9 V batteries in accordance with the polarity markings inside the battery compartment [E].
Note: do not use rechargeable batteries as these might influence the performance.
• Close the cover [D].
WARNING:
Malfunction may occur if the power is on when the battery is replaced. Dispose of batteries
in accordance with local regulations.
Keep batteries away from children.
10. Technical specifications
See front cover for applicable frequencies.
frequency response
frequency stabilization
system
dynamic range
total harmonic distortion
audio output level
power consumption
S/N ratio
spurious image rejection
receiver
DE-emphasis
power supply
dimensions
weight
modulation type
output power
max. deviation
microphone
spurious emission
power supply
dimensions
weight
Use this device with original accessories only. Velleman nv cannot be held responsible in the event of
damage or injury resulted from (incorrect) use of this device. For more info concerning this product,
please visit our website www.hqpower.com. The information in this manual is subject to change
without prior notice.
© COPYRIGHT NOTICE
This manual is copyrighted. The copyright to this manual is owned by Velleman nv. All worldwide rights
reserved. No part of this manual may be copied, reproduced, translated or reduced to any electronic medium or
otherwise without the prior written consent of the copyright holder.
18/11/2010
MICW33x
40 Hz – 15 kHz (+3 dB)
< ±30 ppm
> 90 dB
< 0.8%
0 ~ ±400 mV
1 W
> 90 dB
> 80 dB
50 µs
12 ~ 17 VDC, 300 mA (PSU incl.)
152 x 100 x 27 mm
200 g
FM
10 mW
± 20 kHz
> 40 dB
1x 9 V E-block battery (6F22C, incl.)
Ø45 x 250 mm
230 g
5
Rev. 01
®
©Velleman
nv
Publicité
