Be Cool SUN Instructions page 55

mind that not all vehicle seats may have Isofix
anchor points. The restraint system may not be
used without the device)
1. Store the harness away and remove the padded
waist support.
2. Set the backrest to position 1
3. Connect the Isofix guide to the device (optional)
4. Extend the two sides of the Isofix as far as they
will go.
5. Hold the safety seat and connect the Isofix base to
the device.
6. You will hear it click when correctly inserted
7. Check that the indicator has the same number.
If the indicator displays the red signal, try the
procedure again
8. Push the safety seat until it is in firm contact with
the vehicle seat.
9. Pull the safety seat to check that the Isofix system
is locked.
10. Check that the Isofix anchor is correctly con-
nected.
11. Seat the child in the car safety seat.
12. Set the headrest to the correct height for the child
If the headrest is not at the correct height it is not
safe.
13. pass the 3-point seat belt through the correspon-
ding belt guides and check that the child's pelvis
is held comfortably but securely.
14. Pass the vehicle seat belt through the red locking
device
15. Tighten the seat belt after hooking it in the anchor
point and make sure it clicks into place. (Make
sure the seat belt is not twisted)
EN
55