Lanaform Power Trio Mode D'emploi page 6

ASSEMBLY INSTRUCTIONS
EN
1) Take hold of the lower column and place it close to the base and connect the electrical plug to the base. Insert the end
of the column into the base of the equipment until the screw holes are correctly aligned.
2) Once the parts are in place, tilt the equipment on its side and use 6 M8x35 screws to assemble the base and the
column. For every screw add 1 washer and one M8.2 lock nut.
To make assembly easier, we suggest you install the appropriate screws, then tighten them half-way. Once this stage is
complete, you can tighten them all the way in.
3) Assemble the upper column to the lower column. Place one part facing the other to connect both electrical plugs.
Then fit the 2 columns together, using the M6x25 screw.
4) Take the parts that make up the handle and connect the power cables, as shown on the diagram. Use 2 M6x16 screws
to fix the lower part of the handle to the column. For every screw, add an M6 lock nut.
5) Do the same on the opposite side, taking care to fit both upper parts of the handle together correctly.
6) Assemble the two upper parts of the handle, using the two M5x10 screws.
7) Place the seal over the join of both parts of the handle and fit them together.
Your equipment is now ready for operation.
CONTROLS
Main control panel
1. Screen displaying level of intensity
2. Power button
3. Mode display screen
4. Button for increasing workout time
5. Time adjustment button
6. Workout time digital screen
7. Button for reducing workout time
8. Duo button for switching over to dual function
mode: oscillating-vibrating
9. "Up and down" button for switching over to
oscillating mode
10. Button for selecting different modes
6