CST/BERGER MAGNA-TRAK 200 Serie Manuel D'instructions page 7

DESCRIPTION
The metal detector consists of:
Housing
The housing consists of impact-resistant, water-repellent plastic. It is used as a retainer for the
electrical and electronic equipment and also as a handle.
The weight distribution and arrangement of the operating buttons enable comfortable
single-handed operation.
Measuring rod
The waterproof attached aluminium pipe incorporates the precisely justified sensor coils.
Power supply
6 1.5 volt "AA" batteries for approximately 25 h. operating period. The batteries are located in a
quick-release battery holder.
Control panel
The display, switch and key are located on the front side of the casing. The field intensity and
volume are set with the "PLUS – MINUS" keys.
Display
The display shows the intensity of a signal received as a figure between 0 and 99 and as an
analogue value via a bar chart.
The bar chart also shows the side of the measurement point on which the centre of the item is
located.
Moreover, the volume level set and the field intensity are both displayed.
Loudspeaker
A water resistant loudspeaker is used to emit acoustic signals. A low standard tone changes in
accordance with the signal intensity from objects detected.
Carrying case
A carrying case with a shoulder strap which protects the device during transport is provided.
MT200 Series Locators • 7