CST/BERGER MAGNA-TRAK 200 Serie Manuel D'instructions page 6

INTRODUCTION
EN
The metal detector MAGNA-TRAK is
designed to detect ferromagnetic items. The
MAGNA-TRAK locates ferruginous underground
items such as conduits, receptacles, joining
elements, manhole covers etc.
INCLUDES
The scope of delivery includes:
1 Type MAGNA-TRAK metal detector
1 carrying case
6 1.5 V AA batteries
1 set of operating instructions
INTENDED USE
Any use above and beyond this shall be deemed
non-intended. Our company cannot be held liable
for damages resulting from this.
SAFETY
Warning! Take care if the device detects
unidentifi ed items. They can be harmless waste,
buried contaminated items, ammunition, mines or
duds. In case of any doubt, the responsible
security organs must be informed.
Work on the device may only be carried out by
trained and authorised staff.
The metal detector MAGNA-TRAK should only be
operated with a closed battery cover. (Fig. 2)
MAIN SWITCH
The main switch for the metal detector
MAGNA-TRAK is located on the front side
below
the display. It functions as an "ON – OFF" key.
6 • MT200 Series Locators
General symbols used for the operating
instructions
The following symbols are used to draw
attention to features in the operating
instructions.
Observe the additional
information!
(1)
Main switch on - off
(2)
Plus
(3)
Minus
(4)
Erase
(5)
Loudspeaker
(6)
Volume
(7)
Signal strength
(8)
Analogue signal
(9)
Battery charge state