Argo SWAN EVO Instructions D'utilisation page 31

(7) SLEEP BUTTON
In cooling mode, press the UP and FAN buttons to activate the Sleep mode, after which the unit will return to
the silent mode and save energy.
N.B.:
The Sleep function is not available in the dehumidifying or fan modes.
(8) TEMPERATURE AND ERROR DISPLAY
Problem Cause
FL Tank full of water.
E1 Room temperature sensor failure.
E2 Failure of temperature sensor on the
evaporator.
WARNING!
Before carrying out any cleaning or maintenance operations, unplug the appliance.
1. Cleaning the air filters
Use a vacuum cleaner to remove the dust from the filters.
Should this not suffice, wash the filter with lukewarm water
and some neutral detergent (if necessary), then rinse it
thoroughly in cold water and leave it to dry in air before
putting it back in place. Once the filter has been replaced,
close the grille and resume use of the air conditioner.
2. Cleaning the casing.
Use a damp and soft cloth to clean the outer surface of the appliance.
Do not use excessively hot water, solvents, petrol or other aggressive chemical compounds, talcum powder or brushes:
these may damage the surface or colour of the casing.
Remove any stains using lukewarm water with a little neutral detergent.
Do not pour water onto the air conditioner to clean it, as this may damage its internal components or cause a short-circuit.
3. Storage.
When the air conditioner is not expected to be used for a long time, clean the filters before storing it away.
Keep the appliance in a vertical position at all times. Do not place heavy objects on top of the air conditioner. It is advisable
to protect the appliance with a plastic sheet.
4. Transport.
Transport the air conditioner in the vertical position.
Should this not be possible, rest it on its right-hand side; when the
appliance reaches its final destination, place it immediately in the
vertical position and wait at least 4 hours before operating it in cooling
mode.
V 02/20
Solution
Empty the tank.
If the problem persists, contact a service centre.
Contact a service centre.
Contact a service centre.
CARE AND MAINTENANCE
The air filters must be checked at least once every two
拆除固定螺丝
weeks of use. Operating the appliance with dirty or
clogged filters will decrease the air conditioner's efficiency
and may cause serious problems.
To remove the upper filter, loosen the central screw and
pull the grille's lever.
31