Installing With Lap-And-Shoulder Or Lap-Only Belt System - Harmony DEFENDER 360 Manuel D'instructions

5. Should you need to loosen the
UAS, push the UAS release button
❺.
! WARNING: NEVER put two UAS
connectors on one vehicle UAS
anchor unless specifically allowed
by the manufacturer ❻.
6. Secure the top of the child
restraint using the top tether strap
(see "Using top tether", pg. 23).
!
Conduct a safety check for a secure
installation (see "Installation safety
check", pg. 31). Perform this test
every time you drive with your
child and whenever you readjust the child restraint as
your child grows.
INSTALLING WITH LAP-AND-SHOULDER
! WARNING: UAS must be stored
when using the vehicle belt. Clip
both UAS hooks to the fabric loops
on each side of the backrest ❶.
1. Place the child restraint flush
against the back of a forward-
facing vehicle seat. Adjust the
recline as necessary (see "Recline",
pg. 27).
2. Thread the vehicle seat belt
through the belt slot opening and
out the other side. See illustrations
for proper routing path of Lap-
and-Shoulder Belt ❷ or Lap-Only
Belt ❸.
3. Buckle the vehicle seat belt. The vehicle seat belt
MUST NOT be twisted.
OR LAP-ONLY BELT SYSTEM
❻
❺
❶
❷
30